Legacy Audio’s new i·V 7 is the most powerful home theater amplifier to date. Featuring state of the art ICEedge® technology, the elegant seven channel amplifier approaches 80% efficiency while delivering 600 watts per channel into 8 ohms all seven channels driven. Such exceptional power is the product of very high current (i) and voltage (V) output capabilities providing stability into low impedances with a peak output current capability of 38A.
i·V 7 Features:
- Short circuit protection
- Thermal protection
- Triggered On/Off
- Standby switch
- Front panel status indicator
Say goodbye to excessive heat and transformer hum. The crystal-clear sound is virtually noise-free and reliability is assured- after all, it’s a Legacy.
The Legacy i·V series is available in a mono-block up to an eight channel configuration.
The i·V 7 features 4 independent power supplies. Each board employs large storage capacitors which allow sustained power, not just peak headroom like most Class D amps. Each of these dual channel boards can deliver more than 1,200 watts total; shared between two channels or dedicated to a single channel.
Take advantage of the increased dynamic capability of today's high resolution recordings with the Legacy i·V amplifier series. You will enjoy a lower noise floor in your recordings, stronger crests and increased dynamic resolution.
With unprecedented power underneath the sleek chassis and front panel meter, the i·V7 is great for multichannel duties, including emerging Atmos® systems. Higher amplifier power assures the proper snap in transients and means dense musical arrangements will avoid the smearing, strain and inevitable distortion as complex passages reach higher levels. If you thought loud car crashes, rocket launches and dinosaur footsteps are all high power is good for, you might also consider the benefits of lower noise floor and increased dynamic resolution.
Power Rating: 660 watts per channel x 7 @ 4 ohms, all channels driven 610 watts per channel x 7 @ 8 ohms, all channels driven
Peak Power: 1.2 kW peak power @ 4 Ohm/ 1kHz with less than 1% distortion
Overcurrent Protection: Breaker reset for excessive sustained current
Inputs: Fully balanced XLR, single-end RCA
Outputs: Gold plated safety approved five-way binding posts.
Damping factor: 750 average, 20Hz to 1kHz
Voltage Gain: 25.8 dB
Dynamic Range: 127 dB, A-weighted
Voltage/Current: 98 Vp/ 38Ap
Input Sensitivity: 5.0 Vp @ 1200W/4 Ohm
Input Impedance: 38 kOhm for both pin 2+ and pin 3-
Channel Separation: 120 dB at 1kHz
Unit Dimensions: 17.5" W x 15.6" D x 5.8" H
Unit Shipping Weight: 31 lbs each